Futaba r617fs channels4/6/2024 ![]() ![]() The signal pin is used by the white or orange wire. The ground pin is used by the brown or black wire in the lead between servo and receiver. These are the two outer pins of the three pins a servo connector is connected to. Place the setup lead onto either a spare signal or ground pin in the Rx.Leave the Tx on but turn the winch off. ![]() If a winch does not respond to the Tx there's no point trying to do setup. First, make sure the winch is working via the Tx.Corrosion is by far the most likely cause of failure. Having trouble programming your E model SmartWinch?Īs long as the winch is working fine other and you just want to make adjustments, then there's really only 3 possible reasons why you're not having success.ġ. Most of the information contained here is useful for any SmartWinch model.įor programming travel etc in non E models, please go to the How to Program a SmartWinch page. All previous SmartWinch models including E models have 5 Volt 1 Amp BEC. Between mid-April 2013 to Dec 2018, receiver suppliy was 6 Volts 5 Amps. This applies to SmartWinch E models produced from December 2018. Note that this online guide mentions SmartWinch BEC as 6 Volts 3 Amp for receiver supply. This is an online version of the SmartWinch User Guide E models revision 2. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |